Cable case

Design of the prototype, appearance and possibilities of universal placement of the housing in vehicles and aircraft. The design was based on usability and quality workmanship. At the same time, the production process for mass production was designed to minimize production costs.

A new technology has been applied that enables the rapid creation of very good-looking shells with properties that perfectly enable their further rapid processing.

Digital designs for the appearance of the case were created and then an adequate form was chosen.

Next, moulds for pressing were designed and created using a milling machine. The first prototypes were produced and iterated and tested to achieve the best appearance and utility value until the final product was produced.

• For the production of the case, Evektor designed and constructed a production machine optimized specifically for the production of the case.
• Detailed documentation has been prepared for the entire production process with complete technological procedures with regard to efficiency and low energy consumption in pressing and sewing, together with a clear list of materials used.
• The documentation also includes a training programme for the operators of the production line with a view to mass production.